Noco GB40 Problemoj: Se vi spertas problemojn kun via Noco GB40 saltstarigilo, estas kelkaj solvoj, kiujn vi povas provi. Certiĝu, ke via kuirilaro estas enmetita ĝuste. La baterio devas esti metita en la fundon de la unuo kaj la arĝentaj kontaktoj sur la baterio estu vicigitaj kun la arĝentaj kontaktoj sur la unuo..
Oftaj NOCO GB40 Jump Starter Problemoj
- Ne Ŝargante
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Ne Ŝargante: Se via Noco Genius Boost GB40 ne ŝargas, la plej verŝajna kialo estas aŭ la baterio aŭ la ŝargilo. Se vi provis malsamajn ŝargilojn kaj kuirilarojn, tiam la problemo povas esti kun la aparato mem.
Por ripari ĉi tion, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, povus esti, ke io malhelpas la parolanton.
Not Working and Solution
Ripari ne ŝargado: Se via Noco GB40 Genius Boost ne ŝarĝas ĝuste, provu anstataŭigi la kuirilaron. Se tio ne solvas la problemon, ĝi povas esti pro misa ŝargilo. En tiu kazo, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Iuj saltaj startigiloj faras klakbruojn kiam ili ŝargas. Ĉi tio estas kutime ĉar la kuirilaro estas tro malvarma aŭ tro varma. Por solvi ĉi tiun problemon, varmigu la kuirilaron antaŭ provi ŝargi ĝin. Alternative, provu uzi malsaman tipon de ŝargilo por via salta startigilo.
Flashing Red & Verda kaj Solvo
If your NOCO GB40 is flashing red and green, estas kelkaj aferoj, kiujn vi povas fari por provi ripari la problemon. Unue, check the battery level and make sure it is charged. Se la baterio estas malalta, charge it for a few hours and then try again. Se la kuirilaro estas ŝargita, try resetting the device by pressing and holding the power button for 10 sekundoj. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Unue, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Se ĉi tio ne funkcias, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Unue, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Poste, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Fine, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, vi eble bezonos anstataŭigi ĝin.
Limited capacity and number of ports
Unue, try resetting the device. Por fari ĉi tion, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Se tio ne funkcias, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Unue, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Poste, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Unue, kontroli la kuirilaron. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Unue, kontroli la bateriojn. Se la kuirilaroj estas malaltaj, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, vi eble bezonos anstataŭigi ĝin.
Oftaj Demandoj
Q1: Kiel mi uzas Noco Genius Boost GB40?
Q2: Kiom longe daŭras Noco GB40?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Ĉu Noco GB40 ŝargas kuirilaron?
Jes, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
Q4: Kiel mi ŝargas Genius GB40?
Q5: Ĉu Noco GB40 devas esti plene ŝargita?
Jes, when you get it, fully charge it before first using it to ensure optimal performance.
Q6: Ĉu mi povas lasi NOCO boost plus gb40 enŝovita?
Jes, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
Q7: Kiel mi scias ĉu Noco genius ŝargas?
Kiam la kuirilaro ŝarĝas, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Kiam la kuirilaro estas plene ŝargita, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
There are a few different ways to reset a Noco GB40 charger. Some people find that they need to do this when their charger is not charging their device or when they are getting clicking noises from the charger.
Remove the battery and memory card from the device. Turn off the charger at the wall. Remove the battery and memory card from the device. Hold down the power button for 3 sekundoj, then remove the battery and memory card. Reinstall both batteries and memory card. Reconnect the charger to the power outlet. Press and hold down the power button for 3 sekundoj, poste liberigu ĝin.
The green light on the charger should turn off after about 10 sekundoj. Turn on the device by pressing and holding down the power button for about 5 sekundoj. Se ĉio alia malsukcesas, vi povas provi restarigi vian aparaton tenante ambaŭ butonojn samtempe dum proksimume 10 sekundoj.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Konkludo
Se vi spertas problemojn kun via Noco GB40-aparato, kiel ne ŝargado aŭ klakbruoj, estas kelkaj aferoj, kiujn vi povas fari por ripari ilin. If all of above solutions fail, eble estas tempo preni vian Noco GB40 por riparoj.