Masalah Noco GB40: Jika Anda mengalami masalah dengan jump starter Noco GB40 Anda, ada beberapa solusi yang bisa kamu coba. Pastikan baterai Anda dimasukkan dengan benar. Baterai harus ditempatkan di bagian bawah unit dan kontak perak pada baterai harus sejajar dengan kontak perak pada unit.
Masalah Umum NOCO GB40 Jump Starter
Itu Noco jenius meningkatkan gb40
- Tidak Mengisi Daya
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Tidak Mengisi Daya: Jika Noco Genius Boost GB40 Anda tidak terisi daya, alasan yang paling mungkin adalah baterai atau pengisi daya. Jika Anda telah mencoba pengisi daya dan baterai yang berbeda, maka masalahnya mungkin dengan perangkat itu sendiri.
Untuk memperbaiki ini, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, bisa jadi ada sesuatu yang menghalangi speaker.
Not Working and Solution
Perbaiki tidak mengisi daya: Jika Noco GB40 Genius Boost Anda tidak mengisi daya dengan benar, coba ganti baterai. Jika itu tidak memperbaiki masalah, itu mungkin karena pengisi daya yang rusak. Dalam hal itu, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Beberapa jump starter mengeluarkan bunyi klik saat mengisi daya. Ini biasanya karena baterai terlalu dingin atau terlalu panas. Untuk memperbaiki masalah ini, panaskan baterai sebelum mencoba mengisinya. kalau tidak, coba gunakan jenis pengisi daya yang berbeda untuk jump starter Anda.
Flashing Red & Hijau dan Solusi
If your NOCO GB40 is flashing red and green, ada beberapa hal yang dapat Anda lakukan untuk mencoba dan memperbaiki masalah. Pertama, check the battery level and make sure it is charged. Jika baterai lemah, charge it for a few hours and then try again. Jika baterai terisi, try resetting the device by pressing and holding the power button for 10 detik. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, ada beberapa hal yang dapat Anda lakukan untuk memperbaiki masalah tersebut. Pertama, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Jika ini tidak berhasil, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Pertama, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Lanjut, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Akhirnya, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, Anda mungkin perlu menggantinya.
Limited capacity and number of ports
Pertama, try resetting the device. Untuk melakukan ini, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Jika itu tidak berhasil, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Pertama, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Lanjut, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Pertama, periksa baterai. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Pertama, periksa baterainya. If the batteries are low, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, Anda mungkin perlu menggantinya.
FAQ
Q1: Bagaimana cara menggunakan Noco Genius Boost GB40?
Q2: Berapa lama Noco GB40 bertahan??
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Apakah Noco GB40 mengisi baterai??
Ya, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
Q4: Bagaimana cara mengisi Genius GB40?
Q5: Apakah Noco GB40 harus terisi penuh??
Ya, when you get it, fully charge it before first using it to ensure optimal performance.
Q6: Bisakah saya membiarkan NOCO boost plus gb40 terpasang??
Ya, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
Q7: Bagaimana saya tahu jika jenius Noco sedang mengisi daya?
Saat baterai sedang diisi, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Saat baterai terisi penuh, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Ada beberapa cara berbeda untuk mengatur ulang pengisi daya Noco GB40. Beberapa orang merasa bahwa mereka perlu melakukan ini ketika pengisi daya tidak mengisi daya perangkat mereka atau ketika mereka mendapatkan suara klik dari pengisi daya.
Keluarkan baterai dan kartu memori dari perangkat. Matikan pengisi daya di dinding. Keluarkan baterai dan kartu memori dari perangkat. Tahan tombol daya untuk 3 detik, lalu keluarkan baterai dan kartu memori. Pasang kembali baterai dan kartu memori. Sambungkan kembali pengisi daya ke stopkontak. Tekan dan tahan tombol daya untuk 3 detik, lalu lepaskan.
Lampu hijau pada pengisi daya akan mati setelah sekitar 10 detik. Nyalakan perangkat dengan menekan dan menahan tombol daya selama sekitar 5 detik. Jika semuanya gagal, Anda dapat mencoba mengatur ulang perangkat Anda dengan menahan kedua tombol sekaligus selama sekitar 10 detik.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 SEBUAH.
Kesimpulan
Jika Anda mengalami masalah dengan perangkat Noco GB40 Anda, seperti tidak mengisi daya atau bunyi klik, ada beberapa hal yang dapat Anda lakukan untuk memperbaikinya. If all of above solutions fail, mungkin sudah waktunya untuk membawa Noco GB40 Anda untuk diperbaiki.