„Noco GB40“ problemos: Jei kyla problemų dėl „Noco GB40“ starterio, yra keletas sprendimų, kuriuos galite išbandyti. Įsitikinkite, kad baterija įdėta tinkamai. Baterija turi būti įdėta į įrenginio apačią, o baterijos sidabriniai kontaktai turi būti vienoje linijoje su sidabriniais įrenginio kontaktais..
Įprastos NOCO GB40 starterio problemos
- Neįkraunama
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Neįkraunama: Jei jūsų Noco Genius Boost GB40 neįkraunamas, Labiausiai tikėtina priežastis yra akumuliatorius arba įkroviklis. Jei bandėte skirtingus įkroviklius ir baterijas, tada problema gali būti pačiame įrenginyje.
Norėdami tai išspręsti, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, gali būti, kad kažkas trukdo garsiakalbiui.
Not Working and Solution
Pataisyti neįkraunama: Jei jūsų Noco GB40 Genius Boost įkraunamas netinkamai, pabandykite pakeisti bateriją. Jei tai neišsprendžia problemos, tai gali būti dėl sugedusio įkroviklio. Tuo atveju, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Kai kurie starteriai kraunant skleidžia spragtelėjimą. Paprastai taip yra dėl to, kad baterija yra per šalta arba per karšta. Norėdami išspręsti šią problemą, pašildykite akumuliatorių prieš bandydami jį įkrauti. Arba, pabandykite naudoti kitokio tipo įkroviklį savo starteriui.
Flashing Red & Žalia ir sprendimas
If your NOCO GB40 is flashing red and green, yra keletas dalykų, kuriuos galite padaryti, kad pabandytumėte išspręsti problemą. Pirmas, check the battery level and make sure it is charged. Jei baterija išsikrovusi, charge it for a few hours and then try again. Jei akumuliatorius įkrautas, try resetting the device by pressing and holding the power button for 10 sekundžių. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Pirmas, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Jei tai nepadeda, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Pirmas, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Kitas, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Pagaliau, you’ll want to check the charger itself to make sure that it is working properly. Jei įkroviklis neveikia tinkamai, gali tekti jį pakeisti.
Limited capacity and number of ports
Pirmas, try resetting the device. Padaryti tai, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Jei tai neveikia, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Pirmas, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Kitas, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Pirmas, patikrinkite akumuliatorių. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Pirmas, check the batteries. If the batteries are low, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, gali tekti jį pakeisti.
DUK
Q1: Kaip naudoti Noco Genius Boost GB40?
Q2: Kiek laiko veikia Noco GB40?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Ar Noco GB40 įkrauna bateriją?
Taip, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
4 klausimas: Kaip įkrauti Genius GB40?
Q5: Ar Noco GB40 reikia visiškai įkrauti?
Taip, when you get it, fully charge it before first using it to ensure optimal performance.
6 klausimas: Ar galiu palikti NOCO boost plus gb40 prijungtą?
Taip, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
7 klausimas: Kaip sužinoti, ar Noco genius kraunasi?
When the battery is charging, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Kai baterija visiškai įkrauta, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Yra keletas skirtingų būdų, kaip iš naujo nustatyti „Noco GB40“ įkroviklį. Kai kurie žmonės mano, kad tai reikia padaryti, kai įkroviklis nekrauna įrenginio arba kai iš įkroviklio girdisi spragtelėjimo garsai..
Iš prietaiso išimkite bateriją ir atminties kortelę. Išjunkite įkroviklį prie sienos. Iš prietaiso išimkite bateriją ir atminties kortelę. Laikykite nuspaudę maitinimo mygtuką, kad 3 sekundžių, tada išimkite bateriją ir atminties kortelę. Iš naujo įdėkite baterijas ir atminties kortelę. Vėl prijunkite įkroviklį prie maitinimo lizdo. Paspauskite ir laikykite nuspaudę maitinimo mygtuką, kad 3 sekundžių, tada atleiskite.
Žalia įkroviklio lemputė turėtų užgesti maždaug po to 10 sekundžių. Įjunkite įrenginį paspausdami ir maždaug palaikydami nuspaudę maitinimo mygtuką 5 sekundžių. Jei visa kita nepavyks, Galite pabandyti iš naujo nustatyti įrenginį laikydami nuspaudę abu mygtukus iš karto maždaug 10 sekundžių.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Išvada
Jei kyla problemų dėl „Noco GB40“ įrenginio, pvz., nekraunamas ar spragtelėjimas, yra keletas dalykų, kuriuos galite padaryti, kad juos ištaisytumėte. If all of above solutions fail, gali būti laikas nuvežti savo Noco GB40 remontuoti.